Leapers UTG PRO 34mm 2pcs Med Profile P.O.I Picatinny Rings
The Leapers UTG Pro 34mm 2 pc Medium Profile P.O.I Picatinny Rings are proudly designed and made in the USA. The Low profile P.O.I rings have a 32mm center height to fit optics with a 34mm tube and up to a 63mm outer objective. The innovative P.O.I address 3 of the most critical areas in scope rings. They are progressively machined for a precise inner diameter scope interface to achieve a seamless ring-to-scope interaction. The low profile and flush-fitting locking side plate is controlled by dual spring loaded guide rods interfacing with the rail with Torx screw locking to ensure secure and repeatable zero hold. The square shaped integral recoil stop interfaces with a Picatinny slot via complete surface contact to eliminate the possibility of forward and aft movement from recoil vibrations. These rings are machined from 6061-T6 aluminum alloy and 4605 steel with a matte black hard coat anodize and are designed to fit on Mil-spec 1913 Picatinny rail platforms. Each set of 2 rings is equipped with 4 top Torx screws and designed with a 22mm ring width.
Medium Profile Precision Optics Interface Rings Have a 32mm Center Height to Fit Optics with a 34mm Tube, and up to a 63mm Outer Objective
2 Piece Ring Set, Each Equipped with 4 Top Torx Screws Designed with a 22mm Ring Width
Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms
Machined from 6061-T6 Aluminum Alloy and 4605 Steel with Matte Black Hard Coat Anodize
UTG PRO Original Snag-free Contoured Profile with Reduced Weight and Size
WARNING: This product can expose you to chemicals including lead or DINP, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Medium Profile Precision Optics Interface Rings Have a 32mm Center Height to Fit Optics with a 34mm Tube, and up to a 63mm Outer Objective
2 Piece Ring Set, Each Equipped with 4 Top Torx Screws Designed with a 22mm Ring Width
Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms
Machined from 6061-T6 Aluminum Alloy and 4605 Steel with Matte Black Hard Coat Anodize
UTG PRO Original Snag-free Contoured Profile with Reduced Weight and Size
WARNING: This product can expose you to chemicals including lead or DINP, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
© A Plus Gun Accessories. All Rights Reserved.
